Wolf IS15/S Spécifications télécharger pdf (Page 3)

3

INSTALLATION REQUIREMENTS

IMPORTANT NOTE:

Save these Installation

Instructions for the local inspector’s use.

Please read the entire Installation

I

nstructions prior to installation.

This installation must be completed by a

qualified technician.

Installer:

please retain these instructions

for local inspector’s reference, then leave

them with the homeowner.

Homeowner:

please read and keep

these instructions for future reference and

be sure to read the entire Use & Care

Information prior to use.

IMPORTANT NOTE:

This appliance must be

installed in accordance with National Electri-

cal Codes, as well as all state, municipal and

local codes. The correct voltage, frequency

and amperage must be supplied to the appli-

ance from a dedicated, grounded circuit

which is protected by a properly sized circuit

breaker or time delay fuse. The proper

voltage, frequency, and amperage ratings are

listed on the product rating plate.

Record the model and serial numbers before

installing the steamer module. Both numbers

are listed on the product rating plate located

on the underside of the module. Refer to the

illustration below.

BEFORE YOU START

IMPORTANT NOTE:

Installation and service

must be performed by a qualified installer or

s

ervice agency. Warranty service must be

performed by a Wolf authorized service center.

Installation of the steamer module must

meet the minimum clearance requirements

f

or safe operation. Refer to Site Preparation

on page 4.

Electrical installation must be adequate

and in compliance with all local codes and

ordinances. Electrical ground is required,

refer to Electrical Requirements on page 8.

The steamer module must be installed with

a drain connection and access to the drain

through the base cabinet. Refer to Drain

Connection on page 6.

If the steamer module is to be used with

any combination of additional cooktop units

or modules, refer to Multiple Cooktop

Installation on page 6.

IMPORTANT NOTE:

A ventilation hood is

recommended (but not required) for use with

the Wolf electric steamer module.

This module is intended for indoor use.

WOLF STEAMER MODULE

M

odel IS15/S

Rating plate location

Model Number

IS15/S

Serial Number

Location of rating

plate under module

1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire