Wolf 914 Guide d'installation télécharger pdf (Page 7)

Gas Rangetop Specifications 7

wolfappliance.com/specs

IMPORTANT NOTE: Y

ou must follow all National Electrical

Code regulations. In addition, be aware of local codes and

ordinances when installing your service.

WIRING DIAGRAM

The wiring diagram covering the control circuit is located

under the drip pan that supports the burner grates, inside

the left side panel of the rangetop. The wiring diagram for

French top models (except model RT484F) is located

inside the right side panel.

Electrical Requirements

The Wolf gas rangetop requires a 110/120 V AC, 50/60 Hz

electrical supply to operate the electronic ignition system.

The service should have its own 15 amp circuit breaker. A

ground fault circuit interrupter (GFCI) is not recommended

and may cause interruption of operation.

The power cord is equipped with a 3-prong, grounding

plug for protection against shock hazard. The power cord

must be plugged into a mating 3-prong grounded outlet,

grounded to conform with the National Electrical Code,

ANSI/NFPA 70 latest edition, or Canadian Electrical Code

(CSA) and all local codes and ordinances. Refer to the

illustration below.

IMPORTANT NOTE: This appliance must be properly

grounded to avoid electrical shock hazard. Do not ground

to a gas pipe.

GROUNDING

PLUG

GROUNDED

ELECTRICAL OUTLET

Electrical ground.

ELECTRICAL SHOCK HAZARD: Plug into a grounded

3-prong outlet. Do not remove ground prong. Do not

use an adapter. Failure to follow these instructions can

result in electric shock, fire or death.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

Wolf 914 Guide d'installation Page 7