Wolf Range Guide d'installation Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
Gas Range Installation 15
wolfappliance.com/specs
Oven Door Removal
IMPORTANT NOTE: R
emove the oven door(s) only if it is
necessary to fit the range through a tight doorway.
Removal may cause damage to the porcelain oven interior
or the door(s). Door removal should be done by a qualified
service technician or installer.
For removal, a hinge pin (supplied with the range) must be
inserted in the appropriate hinge arm. For each oven door,
only one hinge arm is spring loaded, requiring use of the
hinge pin for removal of the oven door. The hinge pin can
be found taped to the inside of the oven door.
For single oven ranges, the hinge pin will be inserted
through the hole in the right hinge arm (facing the range).
For double oven ranges, the spring hinges are located on
the outer edges of the unit. The left oven door will have
the spring hinge on the left side and the right oven door
will have the spring hinge on the right side. Refer to the
illustrations below.
SPRING HINGE
Single oven ranges. Double oven ranges.
SPRING HINGES
Failure to insert the hinge pin in the appropriate hinge
arm will cause damage to the range.
Anti-Tip Bracket Installation
WOOD FLOOR APPLICATIONS
After properly positioning the anti-tip bracket, drill
3
/1
6
" (5)
pilot holes through the floor. Use #12 screws and flat
washers to secure the bracket to the floor.
CONCRETE FLOOR APPLICATIONS
After properly positioning the anti-tip bracket drill
3
/8" (10)
holes into the concrete a minimum of 1
1
/2" (38) deep. Use
3
/8" wedge anchors to secure the bracket to the floor.
ANTI-TIP BOLT ADJUSTMENT
Once the bracket is secured in place, adjust the anti-tip
bolt at the back of the range so the top of the washer is
7
/8" (22) maximum from the floor. Slide the range into the
opening and verify the anti-tip bolt is engaged. Refer to
the illustrations below.
IMPORTANT NOTE: The top of the range must be level.
Use the adjustable front legs and the rear casters to level
the range.
7
/8" (22) MAX
ANTI-TIP
BOLT
Anti-tip bolt adjustment. Anti-tip bolt engaged.
ANTI-TIP
DEVICE
ENGAGED
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire