Wolf Ranges Guide d'installation télécharger pdf (Page 9)

wolfappliance.com

Anti-Tip Bracket

INSTALL BRACKET

Drywall application | After properly positioning the anti-tip

bracket, mark holes, then use a Philips screwdriver or a low

rpm power drill to drive the wall anchor into the surface of

the wallboard until ush. Pre-drill holes if needed. For hard

wallboard or double-board construction, use a

/4" drill bit.

For solid plaster, use a

/16" drill bit. Refer to the illustration

below. Use #8 screws and at washers to fasten the bracket

to the wall.

Wood oor application | After properly positioning the

anti-tip bracket, drill

/16" (5) pilot holes through the oor.

Use #12 screws and at washers to secure the bracket to

the oor.

Concrete oor application | After properly positioning

the anti-tip bracket drill

/8" (10) holes into the concrete a

minimum of 1

/2" (38) deep. Use

/8" wedge anchors to

secure the bracket to the oor.

INSTALLATION

/8" (22) MAX

ANTI-TIP

BOLT

ANTI-TIP

DEVICE

ENGAGED

Anti-tip bolt adjustment.

Anti-tip bolt engaged.

ANTI-TIP BOLT ADJUSTMENT

Once the bracket is secure, adjust the anti-tip bolt so the

top of the washer is

/8" (22) maximum from the oor. Slide

the range into the opening and verify the anti-tip bolt is

engaged. Refer to the illustrations below.

ANTI-TIP

BRACKET

WALL

ANCHOR

Wall anchor installation.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Wolf Ranges Guide d'installation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Wolf Ranges