
11
WOLF BUILT-IN OVEN OPERATION
TIME COOK FEATURE
SETTING CONTROLS
1
)
T
ouch oven
O
N
.
2)
Touch cooking mode, such as
BAKE
.
Change preset temperature if needed.
3)
Touch
COOK TIME
. Use the number pads
t
o set the number of hours/minutes the
oven is to stay on.
4)
Touch
ENTER
. Oven begins to heat after
five seconds. Stop time will automatically
be added to the display. At the end of cook
time, oven turns off.
5)
Touch oven
OFF
or
CLEAR
to clear the
display.
FAHRENHEIT TO CELSIUS
The oven can be changed from Fahrenheit (˚F)
temperature to Celsius (˚C) or vice versa.
SETTING CONTROLS
1)
Oven(s) must be off.
2)
Press and hold
TEMPERATURE
on the
control panel or five seconds for upper or
lower oven.
3)
Touch
COOK TIME
to change to F˚ or C˚.
4)
T
ouch
ENTER
. The new display of C˚ or F˚ is
accepted ten seconds after the selection if
ENTER
is not touched.
TIME-OF-DAY CLOCK
Immediately after the oven is installed, set the
12-hour clock to the current time of day. It may
n
eed to be reset after a prolonged power
failure. The clock is visible on the panel during
all modes. If the upper oven timer is set, the
c
lock will not be visible in the upper oven
display window.
SETTING CONTROLS
1)
Touch
CLOCK
.
2)
Touch number pads to set current time
of day.
3)
Touch
CLOCK
or
ENTER
to start clock.
24-HOUR CLOCK
The time-of-day clock can be changed from a
12-hour clock to a 24-hour clock. After the
clock has been set, touch
TEMPERATURE
for
three seconds, touch
CLOCK
, then touch
ENTER
. Follow the same sequence to change
back to the standard 12-hour clock setting.
OVEN TIMER
Each oven has a timer which operates inde-
pendently from the controls and from each
other. Once a time is set in hours and minutes,
the countdown is seen in the display window.
Only the last minute counts down in seconds.
An audio signal acts as a reminder when the
amount of time runs out. To stop the signal,
touch
CLEAR
. The maximum time that can be
set is 9 hours and 59 minutes.
SETTING CONTR
OLS
1)
Touch
TIMER
for the desired oven.
2)
Touch number pads to set the minutes and
seconds.
3)
Touch
ENTER
to start; touch
CLEAR
to stop
timer set-up.
4)
When timing is complete, touch
TIMER
,
then touch
CLEAR
to clear the timer.
Commentaires sur ces manuels