Wolf ProScaler Guide d'installation télécharger pdf (Page 6)

Wolf Cinema Quick Setup Guide

Before installing any lens, be sure the projector is off. If the projector has been running, be sure

to let it cool down completely. Ensure the front lens cap is on during installation.

NOTE: Remove the small rear lens cap before installing!! Keep the large front cap on.

Electrical Connector:1. Line up the male connector on the lens with the female connector

on the slide assembly.

Insert Lens:2. Align the Tabs on the lens plate lock with the slots on the lens retainer ring.

The lens should slide in about ½”.

Rotate Lens:3. Rotate the lens clockwise until the tabs are tightly secured and the lens

release button locks the lens in place.

Front lens cap

Installing the

Primary Lens

Lens release

Lens retainer ring

Projection Lens*

Male connector assembly (on lens)

Female floating connector assembly

(on lens mount)

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Wolf ProScaler Guide d'installation Page 6