Wolf PW362210 Guide d'installation télécharger pdf (Page 17)

Pro Wall Hood Installation 17

wolfappliance.com/specs

Before servicing, switch power off at the service panel

and lock the service disconnecting means to prevent

power from being switched on accidentally. If it cannot

be locked, securely fasten a prominent warning tag, to

the service panel.

All Pro Wall Hoods

WIRING CONNECTIONS

• Run a 120 V AC, 15 amp circuit power cable from the

service panel to the electrical box on the back plate.

• Run the conduit connector through the holes in the

back plate. Refer to the illustration below for the

location of the electrical box.

• Insert the conduit through the hole on top of the back

plate to the electrical box.

• Remove the electrical box cover from the back plate.

Connect black wire to power supply black wire, white

wire to power supply white wire and green wire to

green wire or bare wire.

• Place all wiring connections inside the electrical box

and reinstall on the back plate in the upper right-hand

corner. Make sure that the wires are secure and that no

wires are pinched between the cover and box.

ELECTRICAL BOX

Location of electrical box.

FILTER INSTALLATION

Slide the grease cups along the bottom edge of the hood

so that the lip of the grease cup overhangs slightly.

To install the filters, orient each filter with lines running

vertically. Position the top edge of the filter as shown in

the illustration below. While pressing up against the

spring, rotate the bottom edge of the filter into position

next to the grease cup. Gloves should be worn when

handling filters.

The illustration below shows a 27" (686) deep wall hood,

with the filter sloping up from front to back. For low-profile

and 24" (610) deep hoods, the filter will slope down from

front to back.

FILTER

GREASE CUP SIDE VIEW

Filter installation.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Wolf PW362210 Guide d'installation Page 17