Wolf Sub-Zero 648PROG Guide d'installation télécharger pdf (Page 6)

PRO 48 Site Preparation 6

Electrical Requirements

Power Supply 115 V AC, 60 Hz

Circuit Breaker 15 amp

Receptacle 3-prong grounding-type

Do not use an extension cord or two-prong adapter.

Do not remove the power supply cord ground prong.

The outlet must be checked by a qualified electrician to

be sure that it is wired with the correct polarity. Verify

that the outlet is properly grounded.

FRONT VIEW

/2"

(1918)

FROM

FLOOR

(178)

(152)

Location of electrical supply.

Electrical Requirements

For PRO 48 models, the electrical supply should be

located within the shaded area shown in the illustration

below. Follow the National Electrical Code and local codes

and ordinances when installing the receptacle. A separate

circuit, servicing only this appliance is required. A ground

fault circuit interrupter (GFCI) is not recommended and

may cause interruption of operation.

Always shut power off at the circuit breaker before

performing any installation, service or maintenance.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Wolf Sub-Zero 648PROG Guide d'installation Page 6