Wolf Sub-Zero 700TF Guide d'installation télécharger pdf (Page 13)

Integrated Installation 13

subzero.com

Water Line Connection

QUICK CONNECT WATER VALVE

For units with an ice maker, the quick connect water valve

and PEX tubing are located on the bottom right side of the

unit.

To connect the ice maker water line, attach the union

fitting to the copper house water supply line. Pull the

coiled gray PEX tubing with red cap and captured nut

toward the house water supply line. Remove and discard

the red cap. Then attach the tubing to the union with the

nut. Tighten all connections. Recoil the excess tubing

under the unit. Refer to the illustration below.

Turn on the water supply and check all fittings for leaks.

Make certain the electrical harness is attached to the

solenoid.

In areas with water of high mineral content, an in-line

water filter is recommended. Make sure the filter is acces-

sible for replacement when necessary.

The ice maker will not fill with water immediately. Allow 24

hours for proper ice production. The first container of ice

should be discarded. As with any new connection, there

may be impurities in the ice from the water supply line.

PEX

TUBING

Top anchoring.

Shut power off at the circuit breaker before making

lectrical connection to the solenoid.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Wolf Sub-Zero 700TF Guide d'installation Page 13