Wolf ICBWWD30 Manuel d'utilisateur télécharger pdf (Page 15)

INSTALLATION INSTRUCTIONS

CABINET SUPPORTS

IMPORTANT NOTE:

When the warming

drawer is installed with a built-in oven,

additional clearance between openings may be

required. Check that oven supports do not

obstruct the interior dimensions required for

the warming drawer.

The warming drawer with stainless steel

drawer front may be supported by either a

solid platform, 51 mm x 51 mm runners or

51 mm x 102 mm runners. The platform or

runners must be level, rigidly mounted and

flush with the bottom edge of the opening.

They must be able to support 91 kg.

If an integrated drawer front is used, it must be

supported by a 16 mm solid platform. The

platform will need to be recessed and allow for

overlap of the warming drawer collar. Refer to

page 18 for additional details. The platform

must be level, rigidly mounted and must be

able to support 91 kg.

IMPORTANT NOTE:

Make sure that the

platform or runners are level. There is no way

to level the warming drawer once it has been

installed.

UNPACK THE WARMING DRAWER

Unpack the warming drawer on a flat surface.

Remove all packaging materials and tape from

inside the warming drawer and discard. Do not

discard the package containing the two wood

screws needed for installation.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 93 94

Pas de commentaire

Wolf ICBWWD30 Manuel d'utilisateur Page 15