Wolf ICBWWD30 Manuel d'utilisateur télécharger pdf (Page 18)

18

INTEGRATED FRONT PANEL

INSTALL CLEATS AND PLATFORM

For an overlay or inset application, you will

need to install a recessed platform and cleats

of the following dimensions into the opening.

Top Cleat Dimensions

749 mm W x 13 mm H x 51 mm D

Side Cleat Dimensions

13 mm W x 232 mm H x 51 mm D

Platform Dimensions

749 mm W x 16 mm H x 603 mm D

Depth of platform may increase depending

cabinet depth.

For an overlay application, the platform and

cleats will need to be recessed 5 mm. For an

inset application, they must be recessed 5 mm

plus the thickness of the decorative drawer

panel, allowing the decorative panel to be

flush with the front of the cabinet. Be sure to

rigidly mount the platform so that it can

support a minimum of 91 kg. Refer to the illus-

trations below.

IMPORTANT NOTE:

In an overlay application,

be sure to recess the cleats no more than

5 mm. Recessing deeper than this may cause

the drawer to not close properly.

WOLF WARMING DRAWER

IMPORTANT NOTE:

Be sure to finish the

inside lip of the opening and the front face of

the shelf and cleats. Some of these areas will

be visible when the drawer is open.

IMPORTANT NOTE:

Be aware of the location

of the mounting holes on the warming drawer

frame to make sure the screws used to attach

the cleats do not interfere with the screw holes

for mounting the warming drawer.

Recessed cleats and platform –

inset application

Recessed cleats and platform –

overlay application

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 93 94

Commentaires sur ces manuels

Pas de commentaire