Wolf C48SS Spécifications télécharger pdf (Page 13)

)LJ

8. Loosen bolts (2) securing blower to motor shaft

then remove blower.

9. If replacing blower only, proceed to last step. If

replacing motor, continue with procedure.

10. Remove mounting nuts and spacers securing

motor mounting brackets (2) to motor mount

panel.

)LJ

A. Remove motor mounting brackets from

motor for reuse.

B. Remove cover from motor junction box,

disconnect wires and remove armored

cable from motor junction box.

C. Inspect the motor insulation located

between the motor mounting brackets and

the motor mount panel. Replace if

damaged.

11. Install motor mounting brackets and armored

cable onto replacement motor.

12. Reverse procedure to install and check for proper

operation.

%URNERORI)ICE+OOD

6TANDARDANDCON9ECTION

O9EN6

1. Access burner for the type of oven being serviced

as outlined under

STANDARD OVEN BURNER

or CONVECTION OVEN BURNER.

2. Remove the orifice hood from fitting.

3. Perform BURNER NOZZLE CHECK.

4. Reverse procedure to install.

5. Check for proper operation.

GA66A)ET<9AL9E6TANDARD

ANDCON9ECTIONO9EN6

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

1. Remove

CONTROL PANEL (30" OVENS) on

standard and convection ovens or lower the

KICK PANEL (24" & 30" OVENS) on standard

24" ovens.

2. Remove pilot tubing and thermocouple from gas

safety valve.

3. Remove inlet and outlet gas lines from gas safety

valve.

ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS

Page 13 of 33 F45471 (0913)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Wolf C48SS Spécifications Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Wolf C48SS