Wolf C48SS Spécifications télécharger pdf (Page 19)

)LJ

3. Remove compression nuts on the inlet and outlet

of solenoid.

4. Remove screws and mounting nuts securing

solenoid to bracket.

5. Disconnect lead wires from solenoid.

)LJ

6. Remove fittings from solenoid for reuse on

replacement valve.

Clean pipe threads and apply thread

sealant that is suitable for use with propane gases.

7. Reverse procedure to install and check for proper

operation.

GRIDDLET+ER0O6TATCO0%O

9AL9E

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

1. Remove

BULL NOSE.

2. Raise griddle plate from the front and support

using 4x4 blocks.

3. Pull thermostat bulb out of the holder for the

thermostat-combo valve being replaced.

NOTE Capillary tube is permanently attached to

thermostat-combo valve.

)LJ

4. Remove

CONTROL BRACKET COVER.

5. If installed, remove compression nut on the

flexible tubing gas line that supplies gas to the

manifold on the adjacent open top burner

section.

ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS

Page 19 of 33 F45471 (0913)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Pas de commentaire

Wolf C48SS Spécifications Page 19