Wolf C48SS Spécifications télécharger pdf (Page 17)

)LJ

3. Fully open door to check operation. If bottom

edge of door rubs the front edge of cavity bottom

then the swivel hinge is not engaged as

described.

A. To seat the swivel hinge, open door

approximately 30° and pull in the same

direction on the door handle. The hinge

should drop into place.

4. Open door and check operation. If okay, remove

bolts and close door. If not okay, remove door

and repeat installation procedure.

5. On convection ovens, verify door switch is

operating properly.

6. Reinstall oven control panel.

7. Raise kick panel.

GA63RE66UREREGULATOR

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

Clean pipe threads and apply thread

sealant that is suitable for use with propane gases.

1. Thread regulator onto pipe hand tight with arrow

pointing in direction of gas flow to the range.

)LJ

2. Tighten regulator securely in horizontal position

with the regulator adjustment upward as

described on regulator.

NOTE Regulator will not function properly without

adjustment screw pointing upward.

3. Connect supply gas line to gas pressure

regulator inlet.

4. Adjust regulator as outlined in

REGULATOR

ADJUSTMENT.

ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS

Page 17 of 33 F45471 (0913)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Wolf C48SS Spécifications Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Wolf C48SS