Wolf C48SS Spécifications télécharger pdf (Page 18)

CON9ECTIONO9ENDOOR

6:ITC+

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

NOTE Door switch is installed on Convection Ovens

only.

1. Remove

CONTROL PANEL (30" OVENS).

2. Remove single mounting nut securing door

switch bracket to safety valve mounting bracket.

3. Remove screws securing door switch bracket to

oven frame and remove bracket from control

area.

)LJ

4. Open door to unoperate the switch.

5. Note lead wire locations and disconnect from

door switch.

6. Remove screws and mounting nuts securing

door switch to door switch bracket.

)LJ

7. Reverse procedure to install and check door

switch for proper operation.

CON9ECTIONO9EN6OLENOID

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

1. Remove door switch bracket as outlined under

CONVECTION OVEN DOOR SWITCH. Allow

bracket to rest at the bottom of control area.

2. Remove screws securing the mounting bracket

that holds the safety valve, oven thermostat and

the oven solenoid to the oven frame.

ENDURANCE / CHALLENGER MODULAR SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS

F45471 (0913) Page 18 of 33

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Pas de commentaire

Wolf C48SS Spécifications Page 18